Yaesu FT-8800R Programming with CHIRP

Upload from CHIRP to the radio

Same process as above with minor variations.

After you have made your edits in CHIRP, save them to disk.

Select menu item Radio->Upload to Radio, press the OK key and quickly press the LEFT LOW key on the radio to place it in RX mode.

If you get an error message check for proper com port selected, cable not plugged into the radio or you just took to long pressing buttons and the transfer timed out. Pressing LOW will put the Radio back in RX mode.

Image of CHIRP uploading to a Yaesu FT-8800R
CHIRP Uploading to the FT-8800R

Otherwise you will be rewarded with a progress bar as shown below.

Radio in RX mode with bar showing uploading to radio progress
Radio in RX mode with bar showing uploading to radio progress

73’s until next time, Jay N0IAI


  1. Would like to know if it’s possible to have, using Chirp, to upload to 8800 showing the VFO frequency instead of the Call, Thanks, Chris

    • Not that I am aware of, need to hold the “Low” key on the right or left side to toggle the mode. And depending on if you have changed the purposes of the P1 to P4 keys on the mic you can also use the P4 key to toggle between Freq and Name.

  2. Jay, Sure would appreciate your input. I have a new FT8800. Hooked up a new cable from “Valley “. It seemed to download the 2 frequencies I had manually input. Then, after repeated attempts, checks of cable, power off/on etc, I cannot get past “Clone Start” by pressing the set key. Just two quick chirps and nothing more.

    Any suggestions would be most appreciated!


    • So it worked once for you as you were able to download the two manually input freqs? Since that occurrence pressing the “set” button at the clone start screen results in a beep? Does the screen change and what button are you pressing?


      • The screen stays at “CLONE START” Just two short beeps. When I hold set again, I sometimes get one longer beep. But, it refuses to go to “CLONE”.

    • Darrell,

      I was probing to ensure that you are pressing the correct button, the set button is the one in the middle. I sold my 8800 several months back upgraded to a FTM400 so I am unable to attempt to reproduce your particular problem. If you are using the correct button I would give Yaesu customer service a ring.

      73, Jay

    • Gene,

      I researched this a little and the 7900 is supported by Chirp. Looking at the manual for the radio it has a clone function which is leveraged by Chirp if you have the correct cable. One of the keys process items with Chirp is to clone from the radio as a first step as this is how Chirp learns what sort of radio is connected.

      Good Luck and 73, Jay

  3. Jay, thank you so much for writing this tutorial out leaving it up. I am a new ham (January this year) and bought an 8800 from a fellow club member at Field Day last weekend. He was kind enough to leave some local repeaters programmed but I am excited to load it up with the repeaters I work while I’m traveling the turnpike to visit my folks.

    Can’t thank you enough for this. I wouldn’t have thought to try cloning mode, in fact I passed right over it in the manual when looking for direction. My only other experience with CHIRP is with my UV-5R which just needs to be on to be accessible. I would have been lost without this write up.


  4. Thanks for this. I was able to program channels from my handheld on to the left side of the radio using this method. Any ideas on how to have the same program or a different one uploaded to the right side of this unit.

1 Trackback / Pingback

  1. Yaesu FT-8800R programming with FTB8800 by G4HFG

Leave a Reply

Your email address will not be published.


This site uses Akismet to reduce spam. Learn how your comment data is processed.